Control Cable; Connecting The Cable (Acceleration) - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
(1)
(3)
(2)
(5)

(1)Connecting the cable (acceleration)

1) Install the wire fixture (36919-1033 ) on the engine-
side acceleration lever.
(2)Wire fixture
(3)Engine-side acceleration lever
(4)Plain washer
Cotter pin
(5) 4) Connections and routing complete
(6)To AI motor
(7)Pass outside of the A/C hose.
(8) 2) Connect the cableÅfs outer adjuster along the near
center of the bracket (acceleration cable).
(9)32 (reference)
(10)Cable (acceleration)
(7)
(8)
(4)
(9)
(10)
h.Control cable
1.Connecting the cable (acceleration)
Connect the cable in the order as shown in the
figure.
2.Routing the cable (acceleration)
Lay the cable in the route as shown at left.
(6)
(13)
(11)
(14)
(11) 3) Join the wire fixture and the cable together and
tighten up the nut.
(12)Guide bar
(13)Take the same route along the A/C hose in this arrow-
marked zone.
(14)Screw in until two threads or so (about 1 mm) stretch
out.
(15)A/C hose
(16)Pass the cable so that the sponge (EPDM material)
around the cable comes to these two guides (6 mm
dia. round bars).
(17)A/C hose
(18)EPDM material (sponge)
III-S-22
Engine
(12)
(15)
(16)
320
(17)
(18)