WSM KX080-3 Service
(3) Lubricating oil drain
Note : If disassembling the rear flange only,
proceed to below 1) of item (7).
1) Invert the travel motor.
2) Loosen and remove the hexagon socket
plug [33] (1 plugs), [34] (2 plugs).
Note : When draining the lubricating oil, place
a container below the workbench.
3) Slowly invert the travel motor and drain the
lubricating oil.
(4) Cover removal
1) Scribe match marks across the joint seam
between hub [1] and cover [8] by using a
paint marker.
2) Look into the seam to locate the gap of ring
[18]. Make a punch mark on the hub [1] at a
point about 20mm (0.79 in.) from the ring
[18] end in circular direction and 7mm (0.28
in.) from the end face of hub [1].
1)(Gap of ring}
2)Cover
3)Ring
4)Hub
IV-S-150
Hydraulic system