Kubota KX080-3 Workshop Manual page 565

WSM KX080-3 Service
4) Loosen and remove the plugs [289] (2
plugs) from the rear flange [201].
5) Remove the O-ring [238] from the plug
[289].
Note : Do not reuse the O-ring [238] which
has been removed.
6) Remove the spring [290], valve [287],
sleeve [288] from the rear flange [201].
7) Remove the O-ring [292], backup ring [294]
from the sleeve [288].
Note : Do not reuse the O-ring [292], backup
ring [294] which has been removed.
8) Remove the piston seal [293] from the valve
[287].
Note : Do not reuse the piston seal [293],
which has been removed.
1) Piston seal
2) Valve
IV-S-157
Hydraulic system