Fixture Removal; Spindle Removal - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
7) Remove the hold flange [3] from the spindle
[2].
8) Write the counter mark of the hold flange [3]
and spindle [2] on the hold flange [3] and
spindle [2] with an oil base paint marker.
Note :This is so the hold flange [3] can be
assembled in the same position as the
spindle [2] before disassembly when
reassembling.
necessary, replace the spindle [2] and
hold flange [3] as a pair (assembly).
(This assembly will hereinafter be
referred to as "spindle assembly".)

(18)Fixture removal

1)Invert the travel motor.
2)Remove the fixtures (2 fixtures).

(19)Spindle removal

1) Fasten two eyebolts in the mounting holes
of the spindle [2] so they are symmetrically
positioned.
2) Hook the hook on the eyebolt, gently and
slowly hoist with a crane, and remove the
spindle [2] from the hub [1].
At this time, the floating seal [31], outer ring
of the tapered roller bearing [22] and oil
seal [132] come off together.
IV-S-164
Hydraulic system
If replacement is