Travel Levers; Adjusting The Lever Neutral Position; Adjusting The Travel Levers; Tightening Torque For The Pilot Valve - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
(1)
1)
2)
(3)
3)
(2)
(4)(5)
(6)(7)
(8)(9)
(10)(11)
(12)
(13)
4)
unit:mm (inch)
II-S-33
f.Travel levers

1.Adjusting the lever neutral position

Fit the levers in position as shown at left.

2.Adjusting the travel levers

Keep them at the neutral position.
(1)Dimension from the step end
265mm (10.4inch) (reference)
(2)To-and-fro difference between left and right
levers Less than 2 mm (0.08inch)
(Finely adjust the left lever with the *-marked
bolts.)
(3)Clearance between left and right levers
15~21mm (0.59~0.83inch)
3.Checking the setup condition
Make sure the valve spool moves over its full
stroke.
Make sure the valve spool moves smoothly.

4.Tightening torque for the pilot valve

RD809-6536 , RD809-6534 To be installed
Tightening torque of *-marked bolts
RD809-6536D To be installed
Tightening torque
48.4~55.9N.m (4.9~5.7kgf.m) 35.7~41.2ft.lbs
(1)Right lever
(2)Left lever
(3)To-and-fro difference between left and right
levers: Less than 2 mm(0.08inch)
(4)Grip (travel)
(5)Washer-fitted machine screw
(6)Lever (travel, right)
(7)Bolt
(8)Lever (travel, left)
(9)Bolt
(10)Pedal (travel, left)
(11)Bolt
(12)Cover (rubber,travel pedal)
(13)PV valve
1)265 5(10.4 0.20)
2)To-and-fro difference between left and right
levers: Less than 2 mm(0.08inch)
3)15~21(0.59~0.83)
4)Neutral position
Machine body