Kubota KX080-3 Workshop Manual page 562

WSM KX080-3 Service
7)Remove the rear flange [201] from the
spindle [2].
Note : Grip the rear flange [201] with both
hands and remove by carefully
straight
forcefully wrenching or beating, the
timing plate [109] could fall and
become damaged.
8) Remove the springs [113] (8 springs).
9) Remove the parallel pins [43] from the
spindle [2].
10)Remove the O-rings [28], [30] from the
spindle [2].
Note : Do not reuse the O-rings [28], [30]
which have been removed.
(8) Disassembly of rear flange mounted parts
1) Place the rear flange [201] on the
workbench in position where its mating face
with the spinclle [2] faces upward.
2) Remove the timing plate [109] from the rear
flange [201].
Note : The mating face with the rear flange
[201] may be difficult to remove due
to adherence of oil. It will come off if
you insert a knife in the casting
groove of the mating face of the rear
flange [201] side and gently lift the
timing plate [109]. Inserting sharp
tools such as a screwdriver in the
mating face will damage the mating
face and cause oil leakage. Do not
use
screwdriver.
IV-S-154
Hydraulic system
upward. If removed
sharp tools such
by
as a