WSM KX080-3 Service
9.Tentatively set the locking ring (221) in the
casing hole using pliers.
Set the locking ringwhere it was before the
disassembly.
Set the locking ring horizontally.
Take care not to damage the casing inside
surface.
Turn the locking ring sharp edge upward.
Caution
10.Set special tool 2 in thecasinghole, and push
it
in
together
andbushuntiI the Iockingring is fit inthe
groove with a click.
Push the tool slowly and carefully so the
casing inside surface cannot be damaged.
11.Set the steel ball (225) in thebush.
12.Set the springseat (218) inthebush.
Install it at the previous position before it
was disassembled.
IV-S-125
Hydraulic system
with
the
return
spring