Hub Section Assembly - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

(1) Hub section assembly

1) Fasten 2 eyebolts in the screw holes of the
hub [1]
positioned.
2) Hookthe hook and wire in the eyebolts,
hoistthe hub [1] with a crane, and set the
hub [1] on the workbench.
Note : While matching the hub bolts of the hub
[1] and
workbench, place the hub [1] gently in
the mounting holes of the workbench.
3) Fasten the hub [1] to the workbench and
tighten the hexagon nuts are symmetrically
positioned.
Caution
Tighten the hexagon nuts securely.
Failure to do so could result in injury if the
travel motor is inverted and falls.
4) Press fit the ball bearing [21] in the hub [1]
with an aluminum rod and hammer.
Note : When pressing ball bearing [21] , be
sure to keep it true and square by
shifting the aluminum rod around and
pushing it in just a little at each spot.
5) Fit floating-seal [31] to hub [1], holding it by
both hands and lowering it slowly into
position.
IV-S-171
Hydraulic system
so they are symmetrically
mounting holes of the