WSM KX080-3 Service
21.Press the bush (412) to the cover (201) using
special tool 1 then Iightly tap to press it in
with a hammer.
Be careful because the end of the bush
comes out of the cover.
22.Install the cover into the casing.
Install it at the previous position before it
was disassembled.
Be careful because the cover moves
upward by the force of the damping
springs (336, 337).
23.Tighten the Allen screw (271) with the torque
specified.
Pay attention to place the cover at
horizontal position.
24.Tentatively set the setscrew (471) and lock
nut (472) on the cam (420).
IV-S-128
Hydraulic system