Crankcase 1 And Crankcase 2 - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

Crankcase 1 and Crankcase 2

(When reassembling)
• Match the crankcase 1 and 2, referring to the flywheel housing's
contoured face.
• Tighten the crankcase 2 mounting screws loosely.
• Tighten up the jig to the specified torque same as the flywheel
housing screw. This helps to minimize the level difference
between the crankcase 1 and the crankcase 2 (at the flywheel
side). Possible gap must be 0.05 mm (0.0020 in.) or smaller.
Crankcase 2 mounting
screw
Tightening torque
Flywheel housing
mounting screw
(1) Crankcase 1
(2) Gap to be smaller than 0.05 mm
(0.0020 in.)
(3) Flywheel Housing
III-S-141
49.0 to 55.9 N·m
5.0 to 5.7 kgf·m
36.2 to 41.2 ft-lbs
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
(4) Crankcase 2
(5) Jig
W1111351
Engine