Kubota KX080-3 Workshop Manual page 576

WSM KX080-3 Service
2) Wipe away the white kerosene adhering to
each part with a clean waste cloth.
Note : Dry the inside surfaces of the hub [1],
spindle [2] and hold flange [3] by
blowing with compressed air in a place
free of dust and moisture. After drying,
coat each part with hydraulic fluid. Let
the inside surface of the rear flange
[101], hydraulic motor parts and RV
gear assembly dry naturally in a place
free of dust and moisture. If the pins
[17] (24 pins) are treated roughly, the
surfaces will become damaged from
mutual contact or lost. Handle the pins
with care.
IV-S-168
Hydraulic system