Kubota KX080-3 Workshop Manual page 559

WSM KX080-3 Service
3) Using an electric drill, make a 2mm (0.08
in.) diameter hole at the punch mark.
Note : Be sure to centerthe drill on the punch
mark, and keep drilling until the ring
starts rising. After drilling clear through
the wall of hub [1], be sure to wipe off
the chippings completely.
4) Insert the steel rod into the drilled hole and
push it into makethe ring [18] comeout.
Note : In this case, the advanced of ring come
out.
5) Pickthe end portion of ring [18] and pull it
out to remove the ring [18] off the groove.
6) Fasten the PF eye bolts in the screw holes
for fastening the hexagon socket plugs [33]
of the cover [8] (2 places).
7) Hookthe hook and wire in the PT eyebolts,
hoist with a crane and remove the cover [8].
Note : If the cover [8] is difficult to remove due
to resistance of the O-ring [29], hoist
while tapping the outer edges of the
cover equally with a plastic hammer.
IV-S-151
Hydraulic system