Kubota KX080-3 Workshop Manual page 606

WSM KX080-3 Service
1 (2)
DR
A1
(1)
4 2
(1)
(1)
4 2
(1)
3
(4)
5
(2)
(2)
PL
B
3
3 (4)
(3)
IV-S-198
1. Fitting the adaptor
Fit the adaptor in position as shown at left.
2. Adaptor tightening torque
G1/4 size
24.5~29.4N.m(2.5~3.0kgf.m)18.1~21.7ft.lbs
G1/2 size
58.8~63.7N.m(6.0~6.5kgf.m)43.4~47.0ft.lbs
3. Assembling procedure
(1)Fit the valve assembly (holding) in position.
(2)Place the bracket (1, H/V) and bracket
(2, H/V) in position, and tighten the bolts
temporarily.
(3)Connect the pipe joint (SG4, 1U), pipe joint
(FG4, 1U) and the pipes.
(4)Tighten up the bolts for the bracket (1, H/V)
and bracket (2, H/V). Be careful not to get the
pipes twisted.
(5) Finally set the cover (H/V) in place.
Bolt tightening torque
17.7~20.6N.m(1.8~2.1kgf.m)13.0~15.2ft.lbs
39.2~45.1N.m(4.0~4.6kgf.m)28.9~33.3ft.lbs
39.2~45.1N.m(4.0~4.6kgf.m)28.9~33.3ft.lbs
(1)Pipe joint (L, G1/4-G1/4)
Bracket (2, H/V)
Bolt
Bracket (1, H/V)
Bolt
Pipe joint (LG4, 1U)
(2)Valve assembly (holding)
Bolt
Pipe joint (L, G2-G3)
Switch (pressure, 35M)
Stay (wire harness clamp)
Bolt
Cover (H/V)
Bolt
(3)Hydraulic cylinder assembly (boom)
(4)Pipe joint (SG4, 1U)
O ring (1UNF)
Pipe joint (LG4, 1U)
O ring
Hydraulic system