Removal Of Spring Inside Cylinder Block; Shaft Removal - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

(14)Removal of spring inside cylinder block

1) Place the cylinder block [104] on the press
bench.
Note : The spring is removed only when
replacing. The spring is removed by
lining up the shaft centers of the
retainer (1) and washer [110] in order
to prevent damage to the cylinder
block [104] through contact.
Cover the cylinder block [104] with a
vinyl sheet to prevent the sliding
surface of the cylinder block [104]
from being damaged.
2) Place the retainer (1) on the washer [110],
and while clamping the retainer (1) with the
press, remove the THS snap ring [146] from
the snap ring groove of the cylinder block
[104] with a pair of snap ring pliers.
1)Press
2)Washer
3)Retalner
4)Snap ring
5)Spring
6)Cylinder brock
Caution
If the press is loosened suddenly, the spring
could jump out resulting in injury. Loosen the
press slowly.
3) Loosen the press slowly until the spring
force is released.
4) Remove the THS snap ring [146], washer
[110], spring [114], and washer [110] from
the cylinder block [104].

(15)Shaft removal

1) Remove the swash plate [103] from the
spindle [2].
Note : At the time of swash plate [103]
removal, the pivot [176] is attached to the
swash plate [103] in some cases.
IV-S-161
Hydraulic system