Kubota KX080-3 Workshop Manual page 598

WSM KX080-3 Service
4)Next find the "D" dimension of the hold
flange [3].
5)Adjust the
measurements taken in 2) ~ 4) and
following procedure.
The "C"
dimension of the hold flanae.
1) Depth micrometer
2) Jig
I. If dimension "D" of the actual hold flange [3]
0.02 mm
dimension "C" : Cut the "E" surface of the
hold flange [3] down to the specified
dimension with a turning machine, etc..
II. If dimension "D" of the actual hold flange [3]
is within tolerance * 0.02 mm (0.00079 in.)
of specified dimension "C" :
Use the unmodified hold flange [3] as it is.
1) "E" inner surface
2) Hold flange
III. If dimension "D" of the actual hold flange
[3] is 0.02 mm or larger than specified
dimension "C" :
Replace with a new spindle assembly.
A new hold flange [3] in always provided
with an arrangement allowance.
Note : The hold flange and spindle have been
machined as a pair and are therefore
con figured as an assembly.
The hold flange alone therefore cannot
be replaced.
At this time, the spindle must be
replaced together with it.
This assembly is referred to as the
"spindle assembly".
If replacing by spindle assembly,
perform disassembly and assembly
again.
6) Remove the main Brg pre-load adjustment
jig from the spindle [2].
7) After completing hold flange adjustment by
the adjustments of items I , II, Ill, proceed to
the process of (3) section (3).
IV-S-190
Hydraulic system
hold flange [3] with
dimension is the specified
or smaller than specified
the