Shaft Direction Clearance Adjustment Of The Tapered Roller Bearing - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
(20) Shaft direction clearance adjustment of the
tapered roller bearing
Note : If the following parts are replaced, the
shaft direction clearance of the tapered
roller bearing [22] must be adjusted to
the
adjustment of the snap ring [20].
If you reassemble without adjusting, it
could cause the GM motor to operate
poorly or break down prematurely.
Spindle kit, RV gear assembly
If not replacing the parts listed above,
snap ring adjustment is unnecessary,
and main assembly is carried out from
section (6) as is.
Shaft direction clearance adjustment
method of the tapered roller bearing is
as follows.
1)Tap the outer ring of the tapered roller
bearing [22] attached to the crank shaft [9]
with a hammer and retainer (4).
Note : This is in order to reliably insert the RV
gear assembly in the spindle [2].
2) Mount the thinnest ring [20] in the snap ring
groove of the hold flange [3].
3)Tap the ring [20] side with a hammer and
retainer (4).
Note : Check whether the RV gear assembly
has been reliably inserted in the spindle [2].
IV-S-191
Hydraulic system
specified value by thickness