Track Adjustment; Fitting To The Track Frame; Spring Preset Length; Adjusting The Crawler Tension - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
(A)
(B)
(C)
1
(3)
1
(D)
(1)
2 3
319mm(12.6inch)
(2)
2 3
334mm(13.1inch)
(4)
II-S-65
p. Track adjustment
1.Grease management
No grease leak is allowed.
* Wipe off grease deposits around.

2.Fitting to the track frame

Make sure the crawler slides smoothly.
* Do not force it into position.

3.Spring preset length

*Set the cotter pin into the hole closest to the
dimension specified at left.
(Rubber crawler type) 319mm(12.6inch)
(Iron crawler type) 334mm(13.1inch)

4.Adjusting the crawler tension

Measure at the third roller.
(Rubber crawler type) 25~40mm(1.0~1.6inch)
(Iron crawler type) 40~55mm(1.6~2.2inch)
(A)Master pin insertion position: View from the lock pin
side
(B)Be careful not to confuse the lock pin bending direction.
Bend the lock pin as parallel as possible to avoid
turning.
(C)Sprocket side
(D)Idler side
Rubber track type
No. Part name
1 Idler assembly
2 Cylinder assembly
3 Spring assembly (rubber)
Iron track type
No. Part name
1 Idler assembly
2 Cylinder assembly
3 Spring assembly (rubber)
(1)Set the cotter pin into the hole inside.
(2)Set the cotter pin into the hole outside.
(3)Rubber track
(4)Iron track
Machine body