Assembly Of Srv In The Rear Flange - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
Note : Apply hydraulic fluid to the spool [223]
and insert The spool [223] into the rear
flange [201]
When mounting the spool [223], match
the hole center of the rear flange [201]
with the shaft center of the spool [223]
in order to prevent damage of the rear
flange [201] by contact and damage of
the outer circumference surface of the
spool [223].
If damage by contact is produced on
the hole section of the rear flange [201]
and spool [223] outer surface, after
assembly, it will cause internal leaking
and
performance of the travel motor.
The clearance between the rear flange [201]
and spool [223] in adjusted.
If replacing, replace by rear flange kit.
4) Insert the spool [223] in the rear flange
[201].
5) Mount the O-rings [236] (2 rings) on the
plugs [224] (2 plugs).
Note : Apply grease to the O-rings [236].
6) Screw the plugs [224] (2 plugs) in the rear
flange [201] and temporarily tighten.
7 )Insert the steel ball [296] in the mounting
hole of rear flange [201].
8) Temporarily tighten the plug [284].

(13)Assembly of SRV in the rear flange

1) Mount the O-rings [291], [292], back up ring
[294], [295], on the sleeve [288].
2) Mount the O-rings [238] on the plugs [289].
Note : Apply grease to the O-rings [291],
[292], [238].
IV-S-182
Hydraulic system
will cause a reduction in