Gm Motor: Cleaning The Parts - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
30.Cleaning the parts
1) Put the parts into the kerosene contained in a
rough-cleaning container, and clean them.
(Rough-cleaning)
If the parts are washed immediately after
put into the kerosene, they are easily
scratched. Wait until contaminations and
oily substances are detached and floated
on the surface of the kerosene.
Contaminated kerosene tends to cause
the parts to be damaged, and the
performance
degraded after they are assembled.
Pay much attention to the degree of
contamination of the kerosene.
2) Put the parts into the kerosene contained in a
finish-cleaning container, and rotate them
slowly untiI their internal surfaces can be
cleaned well (Finish-cIeaning).
Wipe out the kerosene from the parts with a
clean waste cloth.
Do not dry the parts with compressed air.
Otherwise, they may be scratched or
rusted with the dust or moisture in the air.
31.Preventing the parts from rusting Apply a rust
inhibitor to the parts.
Leaving the parts without wiping the
kerosene causes them to rust, resulting in
degraded performance after assembled.
IV-S-121
Hydraulic system
of the parts becomes