Flywheel Housing; Crankcase 2 - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

Flywheel Housing

1. Remove the flywheel housing.
(When reassembling)
• Tighten the flywheel housing mounting screws with even force
on the diagonal line.
• Make sure the crank cases 1 and 2 are clean. Install them in
position, referring to the flywheel housing's contoured face.
Flywheel housing
Tightening torque
mounting screw
(1) Flywheel Housing

Crankcase 2

1. Remove the crankcase 2 (1).
(When reassembling)
IMPORTANT
• Make sure the crankcase 1 and 2 are clean.
• Apply liquid gasket (Three Bond 1217D) to the crankcase 2
as shown in the figure.
• Tighten the crankcase 2 mounting screws with even force
on the diagonal line.
• Confirm that the liquid gasket coating surface is free of
water, dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly.
NOTE
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
Crankcase 2 mounting
Tightening torque
screw
(1) Crankcase 2
III-S-140
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 ft-lbs
W1060705
49.0 to 55.9 N·m
5.0 to 5.7 kgf·m
36.2 to 41.2 ft-lbs
(2) Liquid Gasket
W1060825
Engine