Face Sealing (Ors) Type; Connecting The Face Sealing (Ors) Type Hose - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
Screw size
9/6UNF
11/16UNF
13/16UNF
1-14UNS
Part code of O ring
RD809-6184Δ
RD809-6161Δ
RD809-6162Δ
RD809-6163Δ
(1)

1.Face sealing (ORS) type

Tighten to the specified torque.
9/16UNF size
35.2~43.1N.m (3.6~4.4kgf.m) 26.0~30.8ft.lbs
11/16UNF size
60.0~73.5N.m (6.1~7.5kgf.m) 44.3~54.2ft.lbs
13/16UN size
70.6~86.2N.m (7.2~8.8kgf.m) 52.1~63.6ft.lbs
1-14/16UNS size
105.8~129.4N.m (10.8~13.2kgf.m)
78.0~95.4ft.lbs
2.Connecting the face sealing (ORS)
type hose
Take the procedure at left.

Connecting the face sealing (ORS) type hose

1)Remove the protective cap from the adaptor
and make sure the O ring is installed in its
groove. (If the O ring is missing, fit the
specified-size one in position.)
(1)Protective cap
2)Shift the hose's cap nut in the direction of
arrow until the O ring contact face stretched
out of the cap nut.
3) Bring the hose's O ring contact face in close
contact with the joint's O ring.
Make sure they do not come off each other.
4) Tighten up the cap nut to the specified torque.
I-16
General