Spur Gear Assembly - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
Note : f using by replacing the snap ring [20]
only with a new part, select the same
type of snap ring [20] as before
disassembly or one which is similar
from among the 15 types.
2) Mount the snap ring [20] in the snap ring
groove of the hold flange [3].
Note : Match the 3 snap rings [20] with the
counter mark of the hold flange [3],
and mount each in the same position
as before disassembly.
If using a new snap ring [20], mount a
snap ring [20] of the thickness
selected in the previous step in the
snap ring groove.

(7) Spur gear assembly

1) Install the snap ring [25] (3 rings) into the
crankshaft [9].
2) Match the counter marks of the spur gear
[7] (3 gears) and mount on the crankshaft
[9].
Note : Insert the spur gear [7] (3 gears) on the
crank shaft [9] by matching the counter
marks (punch holes) as shown in the
figure below.
1) Position matching marks (punched holes) of spur
gears like this.
2) Hold flange
IV-S-176
Hydraulic system