Spindle Section Assembly - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

(2) Spindle section assembly

1)Apply oil to the O-ring of the floating seal
[31], and mount the floating seal in the
floating seal groove of the spindle [2].
Note : Separate the O-ring parts of floating
seal [31], and Oil it all around, and then
combine itwith the seal ring part. Seat the O-
ring part snugly in the groove, and after fitting
the floating seal [31] in the groove, checkto be
sure that it is true and square in spindle [2].
2) Mount 2 eye bolts in the spindle [2] so they
are symmetrically positioned.
3) Hook the hook and wire in the eyebolts,
hoist the spindle [2] with a crane, and slowly
place the spindle [2] inthe hub [1].
4) Fasten the hub [1] and spindle [2] with
fixtures. At this time, fasten the fixtures so
they are symmetrically positioned
5) Invert the travel motor.
6) Fit the outer rings (3 rings) of the tapered
roller bearing [22] into the respective outer
ring fastening holes in the spindle [2].
IV-S-172
Hydraulic system