Kubota KX080-3 Workshop Manual page 531

WSM KX080-3 Service
3.Tighten the Plug (153) with the torque
specified.
(RCVD8CC only)
4.Attach the washer 3 (313), the washer 2 (217),
the secondary-pressure-setting spring (324),
and the spring seat (311) to the spool (301) in
this order.
The washer 2, whose thickness varies
depending on the spooI assembIy, is for
adjustment to preset the secondary-
pressure-setting spr ing. However, in some
cases, the washer is not used.
5.Stand the spool (301) bottom end upright on a
flat work bench, push the springseat (311)
down then fit 2 semicircular washers 1 (215) to
the spring seat top without overlapping the
washers.
Fit washers 1 with the sharp edges turned
upward and hooked on the spool head.
Do not lower the spring seat by more than
4 mm.
(1)Sharp edge side
IV-S-123
Hydraulic system