Kubota KX080-3 Workshop Manual page 560

WSM KX080-3 Service
8)Remove the O-ring [29] from the cover [8].
Note : Do not reuse the O-ring [29] which has
been removed.
(5) Input gear removal
1) Removethe snap ring [24] from the shaft
[15].
2) Remove the input gear [6], from the shaft
[15].
3) Remove the steel ball [36] from shaft [15].
4) Removethe shaft [15] from the spindle [2]
(6) Spur gears removal
1) Remove snap rings [25] (3 rings) from
crankshaft [9].
Caution
Take notice when taking off the snap ring by
the top with a plierthe snap ring will spring out
of the snap rings hole.
IV-S-152
Hydraulic system