Pin And Bushing Installation; Fitting The Bushings; Dust Seal Fitting Direction; Bushing Setup Direction - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
(2)
(3)
3(0.12in.)
(5)
(A)
(1)
(B)
(4)
(10)
(10)
(8)
C. Pin and bushing installation

1.Fitting the bushings

Using a block or the like, fit the bushings into
position.
* Do not hit directly against the bushings.
2.Bushing setup dimensions
1) Without the dust seals
Make sure the bushings do not stretch out of
both sides.
2) With the dust seals
Ensure the dust seal setup space at both
sides.
(It is possible to control the press-fitting
dimension instead.)

3.Dust seal fitting direction

Fit the dust seals as specified in the figure.

4.Bushing setup direction

Insert the bushings from the 15×-chamfered
side.
With the dust seals
* Bucket link 1, 6 pcs.
* Swing bracket, 2 pcs.
Boom support
* Arm end, 4 pcs.
* Arm support, 2 pcs.
(A)Insert in this direction.
(B)Enlarged view of dust seal
(1)Block
(2)Bushing
(3)Bushing side
(4)Outside
(5)Dust seal
(6)Bushing
(7)Dust seal
(8)Bushing setup direction
(9)Bushing setup direction
(10)More than S
(6)
(10)
II-S-27
Machine body
S
5.0mm(0.20in.)
10.0mm(0.39in.)
4.5mm(0.18in.)
6.5mm(0.26in.)
3(0.12in.)
(9)
(7)