Kubota KX080-3 Workshop Manual page 471

WSM KX080-3 Service
(1)
(2)
(3)(4)(5)
4)Fitting the flange (Suction)
Be careful to install the O ring in position.
5)Bolt tightening torque
77.5~90.2N.m(7.9~9.2kgf.m)57.2~66.5ft.lbs
6)Fitting the hydraulic hose (3/16)
Lay the hose in the route as shown at left.
Make sure the hose is tightly hooked. Press-fit
the hose until it clicks. (If not, reconnect it.)
Finally gently pull the hose to make sure it
does not come off.
7)Fitting the plug (Easy Touch)
Fit the plug tight enough.
Notes:
1. To pour hydraulic oil, remove the plug (Easy
Touch). After adding the oil, be sure to attach the
plug (Easy Touch). Then get the engine started.
2. With the plug (Easy Touch) in place, pull it gently
to make sure it does not come off.
(1)Plug (Easy Touch)
(2)Insert the clamp through the member welded on the
arch.
(3)Flange (suction)
(4)O ring
(5)Bolt
(6)Hydraulic hose (3/16)
(6)
IV-S-63
Hydraulic system