Reassembling - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
10. When reassembling
1) Install the snap ring
2) Install the flange
(1)Knock pin
3) Tighten the flange bolt
4) Assemble the pistons and springs.
In principle, each piston should be in the
original cylinder barrel.
As a mark, one piston and one spring should
be remained for remembrance.
5) Assemble and inner parts and gasket.
Subsequent reassembly procedure is just the
reverse to the disassembly.
IV-S-76
Hydraulic system