Assembly Of Cylinder Block Interior - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
10)Fitting the motor shaft [102] slowly into the
spindle [2].
11)Insert the swash plate [103] into the spindle
[2].
Note : Apply lithium grease to the swash plate
[103] where matching surface of
spindle [2].
Make sure that the locating pivot of the
spindle enters the pivot holes of the
swash plate [103].

(9) Assembly of cylinder block interior

Note : Introduce the sharp side of the angled
section of the THS snap ring [146] and
washer [110] as shown in the figure on
the left.
1) Insert parts in the cylinder block [104] in
order of washer [110], spring [114], washer
[110], and THS snap ring [146].
2) Place the cylinder block [104] on the press
bench.
3) Place retainer (1) on the washer [110], and
while clamping with the press, mount the
THS snap ring [146] in the snap ring groove
of the cylinder block [104] with a pairof snap
ring pliers.
Note : Press force of spring [114] is 588 N (60
kgf) 132 lbs or more. Protect by
covering the cylinder block [104] with a
vinyl sheet so the contact surface with
the timing plate of the cylinder block
[104] does not become damaged.
IV-S-179
Hydraulic system