Governor Fork Lever Assembly - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

Governor Fork Lever Assembly

1. Pull off the governor fork lever shaft (1) with the extra bolt (Dia :
4 mm, Pitch : 0.7 mm, Length : more than 25 mm) (2).
2. Unhook the governor spring (3) at the governor fork lever (4)
side.
3. Remove the governor fork lever assembly from the governor
housing (5).
(When reassembling)
• After reassembling the governor housing assembly, check the
movement of the governor fork lever assembly, the speed
control lever and the stop lever.
NOTE
• When assembling the inside parts, put the oil on each inside
part slightly.
• Be careful not to deform the start spring.
(1) Governor Fork Lever Shaft
(2) Extra Bolt
(Dia : 4 mm, Pitch : 0.7 mm,
Length : more than 25 mm)
Boost Arms (If equipped Boost Compensator)
1. Remove the boost actuator (1).
2. Remove the cir-clip (2).
3. Remove the boost arms (3) and the boost spring (4) from the pin
(5).
Tightening torque Boost actuator
(1) Boost Actuator
(2) Cir-clip
(3) Boost Arm
III-S-126
(3) Governor Spring
(4) Governor Fork Lever
(5) Governor Housing
W1139749
39.2 to 45.1 N·m
4.0 to 4.6 kgf·m
28.9 to 33.3 ft-lbs
(4) Boost Spring
(5) Pin
W1141511
Engine