Fuel Hose; Routing Condition; Installing The Protective Tubes - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
Fuel tube Fuel tube length
A 800mm(31.5in.)
B 400mm(15.7in.)
C 1700mm(66.9in.)
D 200mm(7.9in.)
E 440mm(17.3in.)
F 3800mm(149.6in.)
Hose clamp
(1)
45(1.8in.)
Protective tube length
705mm(27.8in.)
300mm(11.8in.)
1650mm(65.0in.)
150mm(5.9in.)
350mm(13.8in.)
1450mm(57.1in.)
2100mm(82.7in.)
14911-4275
Pipe clip
14971-4275
Pipe clip
(2)
45(1.8in.) 50(2.0in.)
f. Fuel hose

1.Routing condition

Make sure the hoses are out of contact with
sharp edges, hot zones and moving parts.
Do not clamp the fuel hose and electrical cable
together.
See if the hoses are not too tight or locally
sagging.
Be careful not to affect the hose diameter.

2.Installing the protective tubes

Strictly observe the dimensions specified in the
figure.
(1)Fuel tank
(2)Fuel assembly separator
(3)Fuel pump
(4)Fuel filter assembly
(5)Engine
(6)T joint (fuel filter assembly)
(3)
50(2.0in.) 25(1.0n.)
10(0.39in.) 45(1.8in.)
(6)
III-S-17
Engine
(4)
25(1.0n.)
45(1.8in.)
(5)