How To Operate Service Port 1 - Kubota KX080-3 Workshop Manual

WSM KX080-3 Mechanism
3. How to operate servcie port 1
(1) Service port activation switch
(2) Indicator lamp
(3) Service port switch
1. When the lock lever is raised, the service port
activation switch is off.
2. Let the engine warm up after start-up for
approx. 10 minutes under no load conditions.
3-1First Service Port Operation
This switch is used to operate hydraulic attach-
ment such as breakers.
1. Turn the starter key to the RUN position.
2. Lower the lock lever.
3. Push the service port activation switch.
4. Move the service port switch to the right ( )
to send oil to the port (1).
5. Move the service port switch to the left ( )
to send oil to the port (2).
Proportional control allows for slow-to-fast
movement of attachment.
Example: If you move the knob switch half way,
the attachment will move at approximately one-
half speed.
V-M-6
V Electrical System