Remove The Plugwith The Grease Cup (203),Nhu Packing (210) And O-Ring (212) Attached - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
11.Pull out the push rod from the plug.
Note down the positional relationship
between the plug and the push rod.
Take care not to scratch the push rod
surface.
Be careful because the plug may be
pushed out while the push rod is removed.
Caution
12.Remove the plugwith the grease cup
(203),NHU packing (210) and O-ring (212)
attached.
Note down the positional relationship
between the plug and the casing.
Be careful because the piston is pushed
out by the damping spring while the plug is
removed.
Caution
13.Remove the piston (224).
Note down the positional relationship
between the piston and the hole in the
casing.
14.Remove the damping springs (336, 337) from
the casing.
Note down the positional relationship
between the damping spring and the hoIe
in the casing.
IV-S-116
Hydraulic system