Rough Washing Of Various Parts; Finish Washing - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

(24) Rough washing of various parts

1) Divide the hub [1], spindle [2], cover [8],
rear flange [101] parts (4 parts) and other
parts (hereinafter referred to as "internal
parts").
2) Place the hub [1], spindle [2], cover [8] and
rear flange [101] into the washing tank and
wash.
Note : Earth and sand may adhere to the outer
surface of the various parts. Wash well and
remove the earth and sand.
Caution
White kerosene is a combustible.
Beware off ire or burns or injury due to fire.
Note : Injury may occur easily if you wash
various parts which are still dirty in oil
from the beginning. Let soak until the
dirt and grease become loose and
float up.
3)Place the internal part in a rough washing
container of white kerosene and wash.

(25) Finish washing

1) Place the various parts in finish washing
container of white kerosene and wash well
including the inside of parts while slowly
turning.
IV-S-167
Hydraulic system