Connection Of Rear Flange With Spindle - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
2) Fit the parallel pins [241] (2 pins) in the pin
holes of the rear flange [201].
3) Apply grease to the mating face with the
rear flange [201] of the timing plate [109].
Note : Mounting of the timing plate [109] is
carried out until the timing plate [109]
adheres to the rear flange [201].
Adhesion prevents the timing plate
[109] from falling from the rear flange
[201] when mounting the rear flange
[201] on the spindle [2].
4) Mount the timing plate [109] on the rear
flange [201] using the parallel pin [242] as a
guide.
Note : Apply a sufficient amount of grease to
the spring [113], and fix so it does not
fall from the rear flange [201].
5) Mount the springs [113] (8 springs) on the
rear flange [201] and fix with grease.

(15) Connection of rear flange with spindle

1) Mount the O-rings [28], [30] in the O-ring
groove of the spindle [2].
Note : Mount the O-ring [30] without applying
grease. If reassembled with grease
applied, the grease may bleed from
the mating face of the rear flange [201]
and spindle [2] when the travel motor
is running.
This maybe mistaken as an oil leak, so
do not apply grease.
IV-S-184
Hydraulic system