Disassembly Of Hydraulic Motor Parts - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service

(13)Disassembly of hydraulic motor parts

Note : Oil spills from the travel motor when
faced sideways, so place a container under
the travel motor.
1) Tilt the travel motor 90 degrees.
2) Extract the oil from inside the travel motor.
3) Grip the cylinder block [104] with your
hands, turn alternately 2~3 times, and cut
away the shoe [106] bonded to the swash
plate [103].
Note : If you remove the cylinder block [104]
as is, the shoe [106] remains bonded
to the swash plate [103], and the parts
(piston
mounted on the cylinder block [104]
will come off the cylinder block [104]
and fall into the spindle [2],
4) Draw out the cylinder block [104] from the
shaft [102].
Note : At this time the friction plates [115] and
mating plates [116] are also mounted
on the cylinder block [104] and will
come off.
5) Remove the friction plates [115] and mating
plates [116] (2each) mounted on the
removed cylinder block [1 04].
IV-S-159
Hydraulic system
[105], shoe [106], etc.)