Fitting The Sensor (Rpm); Fitting The Plate (Bus Bar); Fitting The Engine Stop Lever; J .Engine Stop Lever - Kubota KX080-3 Workshop Manual

WSM KX080-3 Service
(1)Lever grip
(2)Lever (engine stop)
Nut
(3)Engine stop lever angle
10/Bracket (acceleration cable)
Grommet (engine stop)
(4)Link (engine stop)
Headed pin
Plain washer
Snap pin
(5)Plate (bus bar)
j. Engine stop lever

1.Fitting the sensor (rpm)

Tightening the flange bolt
Fit the sensor in position as shown at left.
Tightening torque
7.8~9.3N.m(0.8~0.95kgf.m)5.8~6.9ft.lbs

2.Fitting the plate (bus bar)

Install the plate between No. 1 and No. 2 nuts at
the air intake of the engine inlet, as shown at left.
Tightening torque

3.Fitting the engine stop lever

Fit the lever in position as shown at left.
(7)
(1)
(2)
(3)
(4)
(4)
(5)
(6)Plate (clamp, 1)
(7)Stay (wire harness clamp)
(8)No. 1 nut
(9)Sensor (rpm)
(10)Details of B
(11)10 (leverÅfs screw setting length)
III-S-24
(1)
(6)
(9)
(10)
Bolt
Bolt
No. 2 nut
Flange bolt
Engine
A
A
A-A (8)
(8)
(11)