Juniper ACX1000 Configuration Manual page 616

ACX Series Universal Access Router Configuration Guide
Verification
Purpose
Action
558
ldp {
auto-targeted-session {
teardown-delay 20;
maximum-sessions 60;
}
interface ge-0/0/0.0;
interface ge-0/0/1.0;
interface ge-0/0/2.0;
interface lo0.0;
}
user@R6# show policy-options
policy-statement per-packet {
then {
load-balance per-packet;
accept;
}
}
user@R6# show routing-options
router-id 7.7.7.7;
forwarding-table {
export per-packet;
}
If you are done configuring the device, enter
Confirm that the configuration is working properly.
Verifying the Routes on page 558
Verifying the LDP Routes on page 560
Verifying the OSPF Routes on page 560
Verifying the Designated Backup Path Node on page 562
Verifying the Backup Neighbors on page 563
Verifying the Routes
Verify that the expected routes are learned.
On Device R6, from operational mode, run the
the routes in the routing table.
user@R6> show route 6.6.6.6/24
inet.0: 75 destinations, 75 routes (75 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
6.6.6.6/32 *[OSPF/10] 02:21:07, metric 1
> to 60.1.1.1 via ge-0/0/0.0
to 80.1.1.1 via ge-0/0/2.0, Push 299872
inet.3: 7 destinations, 7 routes (7 active, 0 holddown, 0 hidden)
commit from the configuration mode.
command to display
show route 6.6.6.6/24
Copyright © 2017, Juniper Networks, Inc.