Juniper ACX1000 Configuration Manual page 668

ACX Series Universal Access Router Configuration Guide
Step-by-Step
Procedure
610
Configuring the Pseudowire Status TLV
Navigate to the [
edit protocols l2circuit
1.
over MPLS.
[edit]
user@host# edit protocols l2circuit
Set the address for the neighbor provider edge router;, this example uses a fictitious
2.
address, 10.255.64.26.
[edit protocols l2circuit]
user@host# set neighbor 10.255.64.26
Specify the name of the interface forming the Layer 2 circuit; this example uses
3.
xe-0/0/0.
[edit protocols l2circuit]
user@host# set neighbor 10.255.64.26 interface xe-0/0/0
Enter the pseudowire-status-tlv statement.
4.
[edit protocols l2circuit]
user@host# set neighbor 10.255.64.26 interface xe-0/0/0 pseudowire-status-tlv
NOTE: You need to configure the virtual-circuit-id statement in order
for pseudowire-status-tlv to work.
Set the virtual-circuit-id statement to identify the pseudowire as regular or
5.
redundant. The identifier value can range from 1 through 4,294,967,295.
[edit protocols l2circuit]
user@host# set neighbor 10.255.64.26 interface xe-0/0/0 virtual-circuit-id 1024
Check your configuration by entering the show command.
6.
Results
[edit protocols l2circuit]
user@host# show
neighbor 10.255.64.26 {
interface xe-0-0-0 {
virtual-circuit-id 1024;
pseudowire-status-tlv;
}
}
] hierarchy level to configure Layer 2 circuits
Copyright © 2017, Juniper Networks, Inc.