Juniper ACX1000 Configuration Manual page 704

ACX Series Universal Access Router Configuration Guide
Verification
Purpose
Action
646
router-id 192.168.0.101;
autonomous-system 64511;
user@PE1# show routing-instances
l3vpn {
instance-type vrf;
interface lt-1/2/0.601;
interface lo0.1;
route-distinguisher 192.168.1.101:64511;
vrf-import l3vpn_import;
vrf-export l3vpn_export;
vrf-table-label;
protocols {
ospf {
export ospf_export;
area 0.0.0.0 {
interface lt-1/2/0.601;
interface lo0.1;
}
}
}
}
If you are done configuring the devices, enter
Confirm that the configuration is working properly.
Checking Layer 2 Circuits on page 646
Checking the Policy Conditions on page 648
Checking Layer 2 Circuits
Upon Layer 2 virtual circuit (VC) establishment, the output of the
command shows the active and the hot-standby VC. In addition, control-plane
connections
details are shown for the hot-standby VC.
From operational mode, enter the
user@A1> show l2circuit connections extensive
Layer-2 Circuit Connections:
Legend for connection status (St)
EI -- encapsulation invalid
MM -- mtu mismatch
EM -- encapsulation mismatch
CM -- control-word mismatch
VM -- vlan id mismatch
OL -- no outgoing label
NC -- intf encaps not CCC/TCC
BK -- Backup Connection
CB -- rcvd cell-bundle size bad
LD -- local site signaled down
from configuration mode.
commit
show l2circuit connections extensive
NP -- interface h/w not present
Dn -- down
VC-Dn -- Virtual circuit Down
Up -- operational
CF -- Call admission control failure
IB -- TDM incompatible bitrate
TM -- TDM misconfiguration
ST -- Standby Connection
SP -- Static Pseudowire
RS -- remote site standby
Copyright © 2017, Juniper Networks, Inc.
show l2circuit
command.