Juniper ACX1000 Configuration Manual page 634

ACX Series Universal Access Router Configuration Guide
Verification
Purpose
Action
576
}
}
user@R1# show routing-options
forwarding-table {
export ecmp;
}
If you are done configuring the device, enter
Confirm that the configuration is working properly.
Verifying the Routes on page 576
Verifying the IS-IS Routes on page 577
Verifying the LDP Routes on page 578
Verifying the Designated Backup Path Node on page 578
Verifying the Routes
Verify that the expected routes are learned.
On Device R1, from operational mode, run the show route command to display the routes
in the routing table.
user@R1> show route 1.1.4/24
inet.0: 14 destinations, 14 routes (14 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
1.1.4.0/24 *[IS-IS/15] 11:37:58, metric 30
> to 1.1.6.11 via ge-1/5/0
to 1.1.1.2 via ge-1/0/0, Push 299824
user@R1> show route 1.1.4/24 detail
inet.0: 14 destinations, 14 routes (14 active, 0 holddown, 0 hidden)
1.1.4.0/24 (1 entry, 1 announced)
State: <FlashAll>
*IS-IS Preference: 15
Level: 1
Next hop type: Router, Next hop index: 262154
Address: 0x98047cc
Next-hop reference count: 8
Next hop: 1.1.6.11 via ge-1/5/0 weight 0x1, selected
Session Id: 0x14b
Next hop: 1.1.1.2 via ge-1/0/0 weight 0x101 uflags Remote neighbor path
Label operation: Push 299824
Label TTL action: prop-ttl
Load balance label: Label 299824: None;
Session Id: 0x142
State:<Active Int>
Age: 11:38:00
Metric: 30
from the configuration mode.
commit
Copyright © 2017, Juniper Networks, Inc.