NEC UNIVERGE SV8100 Features & Specifications Manual page 1064

Issue 5.0
Program
Number
44-01-01
44-02-01
44-02-02
44-02-03
44-02-04
44-03-01
1 - 1054
Program Name
System Options for ARS/F-Route
– ARS/F-Route Time Schedule
Dial Analysis Table for ARS/
F-Route Access – Dial
Dial Analysis Table for ARS/
F-Route Access – Service Type
Dial Analysis Table for ARS/
F-Route Access – Additional
Data
Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
Dial Analysis Extension Table –
Dial
Description/Comments
Set this option to '0' so that the
F-Route table selected is
determined only by the digits
dialed without any relation to the
day or time of the call.
Set the number of digits to be
analyzed by the system for ARS
routing.
Select the Service Type (0 = No
Setting, 1 = Extension Call, 2 =
ARS/F-Route Table, 3 = Dial
Extension Analyze Table).
Enter the additional data required
for the service type selected in
Program 44-02-02, either the
number of digits to be deleted or
the table number to be used.
If enabled (1), this option sends
dial tone to the calling party once
the routing is determined. This
may be required if the central
office at the destination does not
send dial tone.
Set the Dial digits (24 digits
*
#
maximum) 1~9, 0 , @) to be
used for the Dial Extension
Analysis Table. When Program 44-
02-02 is set to type "3", this
program sets the dial extension
analysis table. These tables are
used when the analyzed digits
must be more than eight digits. To
enter a wild card/don't care digit,
press Line Key 1 to enter an @
symbol.
Uniform Numbering Network
UNIVERGE SV8100
Assigned Data
0 = Not Used
1 = Used
(default = 0)
Up to eight digits
(Use line key 1 for a
'Don't Care' digit, @)
(default not assigned)
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
1 = Delete Digit =
0~255 (255 : Delete All
Digits)
2 = 0~500
(0 = No Setting)
3 = Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
0 = Off
1 = On
(default = 0)
Up to 24 digits
*
Digits = 1~9, 0, , #, @
(Press Line Key 1 for
wild character @)
(default = Not
assigned)