X-Ring Pro - Advantech EKI-9516P-HV User Manual

4.4.25

X-Ring Pro

4.4.25.1 Configuration
Use the X-Ring Pro Configuration page to view and configure the X-Ring settings.
To access this page, click Switching > X-Ring Pro > Configuration.
Figure 4.271 Switching > X-Ring Pro > Configuration
The following table describes the items in the previous figure.
Item
Ring ID
Ring Mode
Interface 1
Interface 2
Master Ring
Refresh
Add
Remove
To add a new X-Ring:
Click Switching > X-Ring Pro > Configuration > Add.
Figure 4.272 Switching > X-Ring Pro > Configuration > Add
Description
Specifies a number ranging from 1 to 99 to identify a given X-Ring Pro
group.
Specifies the mode of the X-Ring Pro group. The value is either "Ring"
or "Coupling". The default value is "Ring".

The X-Ring Pro group denoted as mode "Ring" means it is a
switch connected to the other switches to form a ring topology.

The X-Ring Pro group denoted as "Coupling" means it is a switch
that is used to inter-connect two X-Ring Pro networks.
Specifies the first member interface for the X-Ring Pro group. The
value is either physical port or LAG (Link-Aggregation-Group) port.
Specifies the secondary member interface for the X-Ring Pro group.

For the X-Ring Pro group denoted as "Ring", the value is either
physical port or LAG (Link-Aggregation-Group) port.

For the X-Ring Pro group denoted as "Coupling", the value is
physical port or LAG (Link-Aggregation-Group) port or "None".
The value "None" implies the X-Ring Pro group is created not for
coupling dual-homing application
Specifies the X-Ring Pro network that is coupling connected by the X-
Ring Pro group denoted as "Coupling". This field is required for the X-
Ring coupling application only.
Click Refresh to update the screen.
Click Add to add a new X-Ring.
Click Remove to remove the selected entries.
243 EKI-9500 Series User Manual