Pluggables And Cabling Commands; Introduction - Allied Telesis AT-x510-28GTX Command Reference Manual

8

Introduction

Overview This chapter provides an alphabetical reference of commands used to configure
and monitor Pluggables and Cabling, including:
•
•
•
For more information, see the
Configuration_Guide.
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
C613-50102-01 REV C
Pluggables and
Cabling Commands
Cable Fault Locator for finding faults in copper cabling
Optical Digital Diagnostic Monitoring (DDM) to help find fiber issues when
links go down
Active Fiber Monitoring for detecting changes in optical power received over
fiber cables.
"clear test cable-diagnostics
"debug fiber-monitoring" on page 289
"fiber-monitoring action" on page 291
"fiber-monitoring baseline" on page 292
"fiber-monitoring enable" on page 294
"fiber-monitoring interval" on page 295
"fiber-monitoring sensitivity" on page 296
"show system fiber-monitoring" on page 298
"show system pluggable" on page 301
"show system pluggable
"show system pluggable
"show test cable-diagnostics
"test cable-diagnostics tdr
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Pluggables and Cabling Feature Overview and
tdr" on page 288
detail" on page 303
diagnostics" on page 306
tdr" on page 308
interface" on page 309
287