Line - Allied Telesis AT-x510-28GTX Command Reference Manual

U A C
SER CCESS OMMANDS

LINE

line
Overview Use this command to enter line configuration mode for the specified VTYs or the
console. The command prompt changes to show that the device is in Line
Configuration mode.
line vty <first-line> [<last-line>]
Syntax
line console 0
Mode Global Configuration
Usage In Line Configuration mode, you can configure console and virtual terminal
settings, including setting
authentication
lists.
To change the console (asyn) port speed, use this line command to enter Line
Configuration mode before using the
speed (Baud rate) to match the transmission rate of the device connected to the
console (asyn) port on your device.
Note that line configuration commands do not take effect immediately. Line
configuration commands take effect after one of the following commands or
events:
•
•
•
Examples To enter Line Configuration mode in order to configure all VTYs, use the
commands:
awplus#
awplus(config)#
awplus(config-line)#
C613-50102-01 REV C
Parameter Description
<first-line> <0-32> Specify the first line number.
<last-line>
<0-32> Specify the last line number.
console
The console terminal line(s) for local access.
vty
Virtual terminal for remote console access.
(login authentication) or accounting
issuing a clear line console
issuing a reboot command
logging out of the current session
configure terminal
line vty 0 32
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
speed (asyn), length (asyn),
speed (asyn)
command
privilege level, and
(accounting login) method
command. Set the console
168