Allied Telesis AT-x510-28GTX Command Reference Manual page 666

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE INTERFACE
Table 3: Parameters in the show power-inline interface command output
Related show power-inline
Commands
show power-inline interface detail
C613-50102-01 REV C
Parameter Description
Pri
The current PoE priorities for PoE ports on the PSE, as configured
from a
• Low displays when the low parameter is issued. The lowest
• High displays when the high parameter is issued. The
• Crit displays when the critical parameter is issued. The
Oper
The current PSE PoE port state when this command was issued:
• Powered displays when there is a PD connected and power is
• Denied displays when supplying power would make the PSE
• Disabled displays when the PoE port is administratively
• Off displays when PoE has been disabled for the port.
• Fault displays when a PSE goes over its power allocation.
Power
The power consumption in milliwatts (mW) for the PoE port
when this command was entered.
Device
The description of the connected PD device if a description has
been added with the
description is shown for PDs not configured with the
power-inline description
Class
The class of the connected PD, if power is being supplied to the
PD from the PSE.
See the
further information about power classes.
Max (mW)
The power in milliwatts (mW) allocated for the PoE port.
Additionally, note the following as displayed per PoE port:
• [U] if the power limit for a port was user configured (with the
• [L] if the power limit for a port was supplied by LLDP.
• [C] if the power limit for a port was supplied by the PD class.
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
power-inline priority
priority for a PoE enabled port (default).
second highest priority for a PoE enabled port.
highest priority for a PoE enabled port.
being supplied from the PSE.
go over the power budget.
disabled.
power-inline description
command.
PoE Feature Overview and Configuration Guide
power-inline max command).
command:
command. No
for
666