Router-Id - Allied Telesis AT-x510-28GTX Command Reference Manual

OSPF C
OMMANDS
-
ROUTER ID

router-id

Overview Use this command to specify a router ID for the OSPF process.
Use the no variant of this command to force OSPF to use the previous OSPF
router-id behavior.
Syntax router-id <ip-address>
no router-id
Mode Router Configuration
Usage Configure each router with a unique router-id. In an OSPF router process that has
active neighbors, a new router-id is used at the next reload or when you restart
OSPF manually.
Example The following example shows a fixed router ID 10.10.10.60
awplus#
awplus(config)#
awplus(config-router)#
Related show ip ospf
Commands
C613-50102-01 REV C
Parameter Description
<ip-address> Specifies the router ID in IPv4 address format.
configure terminal
router ospf 100
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
router-id 10.10.10.60
960