Allied Telesis AT-x510-28GTX Command Reference Manual page 906

OSPF C
OMMANDS
-
AUTO COST REFERENCE BANDWIDTH
Calculation result = 0.1
Result after rounding up to the nearest integer = 1 (Interface cost is 1)
The auto-cost reference bandwidth value should be consistent across all OSPF
routers in the OSPF process.
Note that using the
cost calculated by the reference bandwidth command.
Mode Router Configuration
awplus#
Example
awplus(config)#
awplus(config-router)#
Related ip ospf cost
Commands
C613-50102-01 REV C
ip ospf cost command on a layer 3 interface will override the
configure terminal
router ospf 100
auto-cost reference-bandwidth 1000
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
906