Log Host Source - Allied Telesis AT-x510-28GTX Command Reference Manual

L C
OGGING OMMANDS

LOG HOST SOURCE

log host source
Overview Use this command to specify a source interface or IP address for the device to send
syslog messages from. You can specify any one of an interface name, an IPv4
address or an IPv6 address.
This is useful if the device can reach the syslog server via multiple interfaces or
addresses and you want to control which interface/address the device uses.
Use the no variant of this command to stop specifying a source interface or
address.
log host source {<interface-name>|<ipv4-addr>|<ipv6-addr>}
Syntax
no log host source
Default None (no source is configured)
Mode Global Configuration
Example To send syslog messages from 192.168.1.1, use the commands:
awplus#
awplus(config)#
Related default log host
Commands
log host
log host (filter)
log host exclude
log host time
show log config
C613-50102-01 REV C
Parameter
<interface-name>
<ipv4-add>
<ipv6-add>
configure terminal
log host source 192.168.1.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify the source interface name. You can enter a VLAN, eth
interface or loopback interface.
Specify the source IPv4 address, in dotted decimal notation
(A.B.C.D).
Specify the source IPv6 address, in X:X::X:X notation.
356