Switchport Remote-Mirror-Egress - Allied Telesis AT-x510-28GTX Command Reference Manual

P M R
ORT IRRORING AND EMOTE
- -
SWITCHPORT REMOTE MIRROR EGRESS

switchport remote-mirror-egress

Overview Use this command on the device receiving remote mirrored traffic to set the
remote mirroring egress port for the specified remote mirroring VLAN. This port
removes the remote mirror VLAN tagging before transmitting the mirrored traffic.
Ingress traffic on this port is disabled.
Use the no variant of this command to reset the port to no longer function as a
remote mirror egress port.
switchport remote-mirror-egress vlan <vlan-id>
Syntax
no switchport remote-mirror-egress
Default There is no remote mirror egress port by default.
Mode Interface Configuration for a switch port
Usage To prevent unwanted processing of mirrored traffic, we recommend configuring
remote monitoring on the receiving device before configuring it on the source
device.
This command would typically be used for the port that transmits the
remote-mirrored traffic to a device that will analyze it. The port effectively
functions as an access port in the remote mirror VLAN, with the added feature of
not allowing ingress traffic on the port.
Example To set port 1.0.1 on the destination device as the remote mirror egress port for
mirrored traffic that is tagged with VLAN ID 2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To unset port 1.0.1 as a remote mirror egress port, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related remote-mirror interface
Commands
show remote-mirror
vlan mode remote-mirror-vlan
C613-50102-01 REV C
M C
IRRORING OMMANDS
Parameter Description
<vlan-id>
The port will transmit the mirrored traffic it receives from this
remote mirror VLAN.
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
switchport remote-mirror-egress vlan 2
no switchport remote-mirror-egress
415